Maintenance methods of the hottest wet gas flowmet

  • Detail

Maintenance method of wet gas flowmeter

650) {this.width=650;} "Title=" maintenance method of wet gas flowmeter "alt=" maintenance method of wet gas flowmeter "/>

maintenance method for water leakage under the dial

1. First remove the three screws on the ring, remove the ring, white washer and glass, as shown in Figure 1.

Figure 1

2. Clamp the needle with pliers, pull it outward horizontally, and take the applicable materials of the needle: plastic plates, pipes, and profiled materials, and then filter them down through the filter, as shown in Figure 2.

Figure 2

3 remove the three screws on the dial with a screwdriver, and then remove them.Dial, as shown in Figure 3.

Figure 3

4. Tighten the nut at the root of the shaft, add water to test, and there is no water leakage. Generally, reinstall it As shown in Figure 4

The sales volume is not going up

Figure 4

there are many water leaks here. The gap of the sealing water jacket becomes larger due to road transportation or temperature difference changes. The above operation is to tighten the sealing water jacket in the nut. This operation is also applicable to the self maintenance of the instrument after long-term operation

there are two types of wet gas flow scoring: one is used, which is generally used in the range of non corrosive gas. The other is the use of materials, which can measure corrosive gases. Lmf/lml series wet gas flowmeter is one of the commonly used instruments in the laboratory. When measuring the total volume of gas, its accuracy is high, especially when the flow is small, its error is small. It can be directly used to measure gas flow, and can also be used as a standard instrument to verify other flow meters

source: Beijing jinzhiye Instrument Equipment Co., Ltd

Copyright © 2011 JIN SHI