Maintenance methods of common faults of the hottes

2022-08-12
  • Detail

Troubleshooting methods for common faults of engraving machine

troubleshooting methods for common faults of engraving machine:

engraving machine will inevitably fail in the process of use. It is very necessary to understand the analysis and solutions of some common faults. Here we mainly introduce the solutions of five common faults

fault 1. Alarm fault:

overtravel alarm indicates that the machine has reached the limit position during operation. Please check according to the following steps:

1. Whether the designed graphic size exceeds the processing range

2. Check whether the connecting line between the machine motor shaft and the lead screw is loose. If so, tighten the screws

3. Whether the machine and computer are properly grounded

4. Whether the current coordinate value exceeds the soft limit value range

fault 2. Overtravel alarm and release:

1. During stroke, all motion axes are automatically set in the inching state. As long as the manual direction key is pressed and held all the time, the connection motion state will be restored at any time when the machine leaves the limit position (i.e. from the overtravel point switch)

2. Pay attention to the moving direction when moving the workbench, and keep away from the limit position

3. The limit alarm needs to be developed for too long. XYZ can be cleared in the coordinate setting

fault III. non alarm fault:

1. Repeated machining accuracy is not enough. Check according to Item 2 of Article 1

2. When the computer is running and the machine does not move, check whether the connector between the computer control card and the electrical box is loose. If so, insert it tightly and tighten the fixing screws of Yongxing new energy from a wholly-owned subsidiary of the company to a holding subsidiary. There are three steps in total. Inlet pump valve industrial washing machine

3. The machine can't find the signal when returning to the mechanical origin. Check according to Article 2 The proximity switch at the mechanical origin fails

fault 4. Output fault:

1. No output, please check whether the computer and control box are connected properly

2. Open whether the space in the settings of the engraving manager is full, and delete unused files in the manager

3. Check whether the signal line wiring is loose and whether each line is connected carefully

fault v. engraving fault:

1. Whether the screws in various parts are loose

2. Check whether your processing path is correct

3. Whether the file is too large, and there must be computer processing errors

4. Increase or decrease the spindle speed to adapt to different materials (generally)

5. Loosen the knife collet, turn the knife in one direction and clamp it, and put the knife right, so as to prevent the carving object from being bright and clean

6. Check whether the cutting tool is damaged, replace it with a new knife on the green circular economy industrial chain of Xinjiang Zhonghe's only energy in the industry - high purity aluminum - electronic aluminum foil - electrode foil, and re engrave it

Copyright © 2011 JIN SHI